![background image](http://html1.mh-extra.com/html/nec/powermate-spb-wash/powermate-spb-wash_user-manual_4143717086.webp)
4-32 Configuring the System
Recovering the BIOS
The following sections describe how to recover the system
BIOS. A BIOS recovery diskette is required to recover the
BIOS. See the NEC CSD Bulletin Board Service or NEC
CSD website to download the system BIOS.
1.
Turn off the power and unplug the system and any
peripherals.
!
WARNING
Turn off the system before you change any
jumper settings.
2.
Remove the access cover (see “Removing the Access
Cover” in Chapter 5).
3.
Locate the Configuration jumper (J8A1) on the system
board (see “Locating the Jumper” in the previous
subsection).
4.
If necessary, remove any installed expansion boards to
access the jumper (see “Removing an Expansion Board”
in Chapter 5).
5.
Remove the jumper block from pins 1-2. We recommend
that you use needle nose pliers to move a jumper.
6.
Replace the access cover (see “Replacing the Access
Cover” in Chapter 5).
7.
Connect system power cables and monitor.
8.
Power on the system.
The system attempts to recover the BIOS. A recovery
diskette is needed.
Summary of Contents for PowerMate SPB-Wash
Page 55: ...4 Configuring the System System BIOS and the Setup Utility BIOS Flash Utility Video Drivers...
Page 161: ...B System Specifications Standard Features Environmental Specifications...
Page 177: ...C System Board Connectors and Error Messages System Board Connectors Error Messages Beep Codes...
Page 220: ...Index 5 Z Zip drive release button data lamp 1 14 using 1 13...