(For United States Use Only)
Federal Communications Commission
Radio Frequency Interference Statement
WARNING: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from the
one to which the receiver is connected.
Use shielded and properly grounded I/O cables and power cable to ensure
compliance of this unit to the specified limits of the rules.
(For Canadian Use Only)
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B repecte toutes les exigences du
Règlement sur le matériel brouilleur du Canada.
Summary of Contents for PowerMate SPB-Wash
Page 55: ...4 Configuring the System System BIOS and the Setup Utility BIOS Flash Utility Video Drivers...
Page 161: ...B System Specifications Standard Features Environmental Specifications...
Page 177: ...C System Board Connectors and Error Messages System Board Connectors Error Messages Beep Codes...
Page 220: ...Index 5 Z Zip drive release button data lamp 1 14 using 1 13...