3-60 Configuring the System
2.
Remove the system unit cover (see “Removing the
Cover”).
3.
Locate the J6C1 jumper block on the system board (see
“System Board Jumper Settings”). Move the jumper to
pins 2 and 3. This jumper setting brings the system up in
Configure mode when it is rebooted.
4.
Replace the system unit cover (see “Replacing the
Cover”). Connect system power cables and external
options.
5.
Power on the system. The BIOS Setup utility launches
immediately after POST, and no password is required.
The Maintenance menu is active.
6.
Select the
Clear All Passwords
field. Press
Enter
. A
Setup Confirmation window appears with the prompt,
“Clear All Passwords Now?” The default is Yes.
7.
Press the left or right arrow key to toggle between Yes
and No. Select
Yes
and press
Enter
to activate the choice.
8.
Select the
Exit
menu with the left or right arrow key.
Press
Enter
to exit saving changes. Press
Enter
again to
confirm that you wish to exit the BIOS Setup utility.
9.
Power off and unplug the system and any external
options. Remove the system unit cover (see “Removing
the Cover”).
10.
Move the J6C1 jumper back to pins 1 and 2 so the system
can restart in normal operation mode.
