NEC N8100-1668F, User Manual

Page: 118 / 572

4-44 Configuring Your Server
Configuration by Onboard RAID Controller
This section describes how to use the internal hard disk drives as RAID System by Onboard RAID
Controller (LSI Embedded MegaRAID

).
Installing the Hard Disk Drives
Install the required number of hard disk drives for the desired RAID level to your server. See
Chapter 9 for installation procedure.
IMPORTANT:
Use hard disk drives of the same revolution. In
addition, use two hard disk drives of the same capacity if you are going
to configure RAID1.
Enabling RAID Feature
To configure a hard disk drive as RAID System, change the RAID System configuration jumper
switch on mother board.
NOTE:
The RAID System is factory-set to "Enabled".
WARNING
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages
1-3 to 1-9 for details.

Do not disassemble, repair, or alter the server.

Do not remove the lithium battery.

Disconnect the power plug before working with the server.
CAUTION
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-9 for details.

Never attempt to lift the server only by two or less persons.

Make sure to complete board installation.

Do not install the server on a rack with leaving covers removed.

Do not pinch your finger with mechanical components.

Note high temperature.

Do not pull out a device from the rack if the rack is unstable.

Do not leave more than one device being pulled out from the rack.