NEC Express5800/120Rf-1, User Manual

Page: 323 / 408

Upgrading Your Server 9-37
8.
Insert the riser card assembly into the slot on the mother board.
Align the riser card terminal section with the slot on the mother board, and firmly push the
riser card until it is fully seated.
NOTE:
„
There are catches on the riser card frame that are used to secure the
riser card to the cabinet. When inserting the riser card, confirm that
the catches are correctly fit into the holes on the rear of the cabinet.
After the insertion, push the riser card with your fingers until you
cannot see any part of the riser card terminal section. The riser card
is now fully seated in the slot.
„
Pay attention not to damage the components on mother board with
the riser card when inserting it into the slot.
9.
Install the components you removed previously.
10.
Verify that POST displays no error messages.
If POST displays an error message, take a note on the message and see the POST error
messages listed in Chapter 8.
11.
Run the BIOS SETUP utility and select "Yes" for [Advanced]
→
[Reset Configuration
Data].
This setting is required to change the hardware configuration data. See Chapter 4 for
details.
Removal
Remove a PCI board in reverse order of the installation steps.