NEC Express5800/120Rf-1, User Manual

Page: 132 / 408

4-36 Configuring Your Server
Creating RAID0 Array
To create a RAID0 array:
1.
Select [RAID-0] on [Select RAID Type] window.
2.
Use the cursor key to move the focus to the desired hard disk drive and determine it by
Space , and then press Enter.
An [X] mark is placed next to the selected hard disk drive.
3.
Select the desired stripe size and press Enter . Available stripe sizes are 16, 32, and 64
KB.
4.
Enter the desired RAID Name in [Assign RAID Name] window.
IMPORTANT:
„
RAID Name must be unique and up to 15 characters are acceptable.
„
If a valid partition information or a boot block is detected in the
selected hard disk drive, a warning message will be displayed.
Select [Yes] to continue creating an array, [No] to terminate.
„
Take sufficient care not to select the proper hard disk drive. If not,
the data will not be restored.
5.
The message "Do you want to make this array as bootable?" to prompt you to specify the
boot priority of the new array appears. Select [YES] to specify, or [NO] to ignore, and
then press
Enter .
NOTE:
The boot priority can be changed after the arrays have been
created. To change priority, see "Boot Priority" described earlier.