NEC Express 5800/120Lh, User Manual, Page: 82 / 314

4-16 Configuring Your Server
Boot
If you move the cursor to the position of "Boot," the Boot menu appears, which is used to set the
boot priority.
The factory-default boot order is listed below.
1. CD-ROM drive
2. Removable Devices
3. Hard Drive
4. IBA GE Slot 0910 v1216
5. IBA GE Slot 0910 v1216
The server searches for devices in the order set in this menu on booting. Finding the boot software,
the server starts the software.
The priority of the boot devices can be changed by using the
↑
,
↓
, + , and - keys. Move the cursor
to the desired device with the
↑
or
↓
key and change the priority with the + or - key.
IMPORTANT:
To boot NEC EXPRESSBUILDER, set the priority of
the devices as shown in the figure above.
Exit
The options on the menu are described below.
Exit Saving Changes
Exit after writing all modified BIOS Setup item values to CMOS.
Exit Discarding Changes
Exit leaving CMOS unmodified. User is prompted if any of the setup fields ware modified.
Load Setup Defaults
Load default values for all BIOS Setup items.
IMPORTANT:
This option sets [SATA RAID Enabled] in the
[Advanced] menu to [Disable]. If the SATA hard disk drives are
installed in your server and the onboard SATA RAID feature is used,
change the parameter of the [SATA RAID Enabled] from [Disable] to
[Enable] before exiting BIOS Setup.
Discard Changes
Read the previous values of the all BIOS Setup items from CMOS.
Save Changes
Write all BIOS Setup item values to CMOS.