NEC Express 5800/120Lh, User Manual, Page: 242 / 314

9-30 Upgrading Your Server
PCI Board
The server contains six slots into which PCI boards can be inserted.
IMPORTANT:
Any PCI board is easily affected by static electricity.
Handle a PCI board after making your body contact with a metallic
frame section of the server to discharge the static electricity on your
body. Do not make bare hands contact with terminals and components
on the PCI board. In addition, do not put the PCI board on a desk
directly. See "Static Precautions" in this chapter for details of the
static electricity.
NOTE:
When a PCI board is installed, removed, or removed from the
present slot and then installed in another slot, modify the detailed
settings including the interrupt lines (IRQ) by using the BIOS setup
utility SETUP if necessary. See Chapter 4 for the settings of the
interrupt line states and I/O spaces at the shipment of the server.
Mother board
*1 The system operates at the rate of 33 MHz when PCI boards operating only at 33 MHz are
installed in these slots.
*2 Do not install a set of PCI boards providing a specific function to extend over both the 64-bit and
32-bit PCI buses.
PCI board slot #6
(64-bit *1 /133MHz)
PCI board slot #5
(PCI EXPRESS #2, 8-bus)
PCI board slot #4
(PCI EXPRESS #1, 8-bus)
PCI board slot #3
(64-bit
*1
/100MHz)
PCI board slot #2
(64-bit *1 /100MHz) *2
PCI board slot #1
(32-bit/33MHz)
*2