NAC Image Technology SP-642, User Manual

Page: 349 / 436

(00292)H 12 - 9
12.3 Auto Pilot Commands
This section describes the commands used for auto pilot sequences.
(†1 ) Block
：
Block Numbers
With the CFRM, PLAYFRMRANGE, SAVEFRMRANGE commands, the Block: block
number is set as a parameter to designate the frame moved, playback or saved frame range.
In the GX camera memory, the first block is block1, with a maximum of 16 block partitions
but with the GX auto pilot command, blocks in the camera memory are designated from
0~15.
Block1 in the GX camera memory is designated block0 with the auto pilot command and
block2 in the GX camera memory is designated block1 with the auto pilot command.
For the Block: block number parameter in the auto pilot command, the number subtracting 1
from the camera block number is specified.
(1)
STOP Stop
【
Function
】
Puts the camera in the STOP mode.
【
Parameter
】
Timeout
：
Timeout setting
Timeout
：
Specify the maximum timeout (seconds) until going into the STOP mode.
-2
：
The camera issues the command for the STOP mode but it jumps to the
command following the sequence without waiting to go into the STOP
mode.
-1
：
The camera issues the command for the STOP mode and it jumps to the
command following the sequence while waiting to go into the STOP
mode.
0
：
The camera issues the command for the STOP mode and waits a
maximum of “Standard Timeout” for the STOP mode.
The “Standard Timeout” is used for the TIMEOUT command setting.
1~2,147,483,647
：
The camera issues the command for the STOP mode and waits the
maximum of the number of seconds specified in Timeout for the STOP
mode.
(2) VIEW View
【
Function
】
Puts the camera in the VIEW mode.
【
Parameters
】
Timeout
：
timeout setting
Timeout
：
Specify the maximum timeout (seconds) until going into the VIEW mode.
-2
：
The camera issues the command for the VIEW mode but it jumps to the
command following the sequence without waiting to go into the VIEW
mode.
-1
：
The camera issues the command for the VIEW mode and it jumps to the
command following the sequence while waiting to go into the VIEW
mode.
0
：
The camera issues the command for the VIEW mode and waits a
maximum of “Standard Timeout” for the VIEW mode.
1~2,147,483,647
：
The camera issues the command for the VIEW mode and waits the
maximum of the number of seconds specified in Timeout for the VIEW
mode.
Caution