Page 28 of 62
© 2021 Multidyne
FN-64-CHAS Product Manual
recommended if using fixed IP assignment by MAC address or if there is a way to determine what IPs the
Multidyne systems get assigned. Otherwise it may become difficult to determine what IP address to use when
accessing the Web Page or other control interfaces. In the event that the IP address or Netmask of a system is
unknown, consult the Unknown IP Address section for this device.
Command
Description
DHCP
Query DHCP enable.
DHCP 0 | 1
Set DHCP enable (0 to disable, 1 to enable)
Examples to query and then enable DHCP
>DHCP
0
>DHCP 1
>
3.10.4
E Command
Routers only
Query or assign matrix routing changes echo enable. A value of 0 disables this feature. A value of 1 will cause
all matrix routing changes to be echoed in the form of an X command: “Xd,s[,l]”. Where 'd' is the destination
number, 's' is the source number and 'l' is the optional level number. This is useful for diagnostic purposes or
automation software which would like to receive synchronous matrix routing state updates.
NOTE:
Enabling this feature may slow down the system significantly during excessive matrix routing changes
(especially when enabled on a serial port interface). Also of note is that this option takes effect only while the
system remains powered (serial port) or for the duration of the connection (TCP/IP telnet sessions). This
command is not supported by the HTTP web command interface.
Command
Description
E
Query matrix echo enable.
E 0 | 1
Set matrix echo enable (0 to disable, 1 to enable).
Examples to query and then enable matrix echo
>E
0
>E 1
>
3.10.5
Firmware Command
NOTE:
Superseded by the
sys.firmware
System Parameter.
Query the system firmware series and version.
Example
>Firmware
Pyxis 1.1.7
