Page 11 of 62
© 2021 Multidyne
FN-64-CHAS Product Manual
•
Routing matrix is initialized to Preset 0 state (defaults to source 1 connected to all destinations).
1.4
Front Status Panel
The FN-64-CHAS has a status front panel with 3 LED indicators, described in the following table:
LED Label
Description
PS 1
Power supply 1 good indicator.
PS 2
Power supply 2 good indicator.
FAULT
Red LED for user configurable faults.
Table 3: Status Panel Indicators
This model is not equipped with a built-in button control panel, however several options are available for
controlling the device, including the web page interface, telnet, RS-232 serial and remote control panels.
1.5
Web Page Interface
All Multidyne routers and panel devices come with a built-in web page interface.
This is the recommended interface for configuration and is also a convenient way to control the matrix routing
of the device.
Devices come factory configured with default settings, unless a pre-configuration request is made during
purchase, an example being a multi device application.
1.5.1
Accessing The Web Page Interface
The default network IP address for this device is 192.168.2.60.
Device Type
Default IP Address
Video/Audio Routers
192.168.2.60
Table 5: Default System IP Address
To access the web page interface of the device:
1.
Connect the Ethernet port of a computer either directly to the device using a straight through or
crossover cable to the same Ethernet network through a network switch or other LAN infrastructure.
2.
Manually configure the computer's IP address to be a
unique
address on the same IP subnet as the device.
For example 192.168.2.10. The Netmask should be 255.255.255.0. A Gateway address is not necessary
for this purpose, but could be set to 192.168.2.1.
3.
Make sure the device is powered on.
4.
Using a web browser on the computer, enter the device's IP address into the Location bar and press
ENTER. The device web page interface should load. If the web page interface fails to load, double
check the computer's network settings and physical Ethernet connections. In the event that the IP
address of the device is unknown, refer to the Unknown IP Address troubleshooting section.