Page 50 of 62
© 2021 Multidyne
FN-64-CHAS Product Manual
Write current matrix routing state to a preset. Recalling the preset later will restore the routing matrix to the
same state. This command modifies preset data which persists through power cycles.
Command
Description
W PRESET
Write current matrix routing state to PRESET.
Example to save state to preset 1
>W 1
>
3.10.47
WebPass Command
Assign a web password to password protect the web page interface. The serial and TCP/IP port MDCP protocol
control is not protected by this password. This value is stored and recalled on power up.
Command
Description
WebPass STR
Set web page password (blank to disable)
Examples of setting and clearing web page password
>WebPass SeCr3t
>WebPass “”
>
3.10.48
X Command
Routers only
Query or make changes to the matrix routing state. This command comes in several variations described by the
following table.
Command
Description
X
Query complete routing state (equivalent to S Command).
X DEST
Query connected sources for DEST for all levels.
X DEST, SRC
Connect SRC to DEST for all levels.
X DEST, SRC, LEVEL
Connect SRC to DEST/LEVEL.
When querying connection state, sources for each level are separated by commas (multi-level systems only) and
are displayed for each destination and separated by newlines.
The value 0 can be used for DEST to switch all destinations to a given source. A level may also be specified to
isolate switching a single level of all destinations.
(Protocol Version 2.2)
The value 0 can be used for SRC to Mute a destination (if supported for a given level).
Examples
>X
1,1