Page 19 of 62
© 2021 Multidyne
FN-64-CHAS Product Manual
Override is also non-zero. If set to 3 for example, the secondary level would be level 3.
2.6
Command Tab
The Command Tab (Figure 29) provides access to the MDCP protocol interface. Commands are typed on the
Command text entry line followed by pressing the Enter key to execute them. The results will be displayed in
the text area below the command line. Clicking the
Clear Output
button will clear all command output in the
lower area.
2.6.1
See the section MDCP Control Protocol for more information.
Figure 29: Command Tab