Page 10 of 62
© 2021 Multidyne
FN-64-CHAS Product Manual
1.2.2
SFP Modules
The FN-8-IN-SFP and FN-8-OUT-SFP modular I/O cards offer additional I/O flexibility down to a single input
or output using industry standard MSA compatible SFP modules. Multidyne offers two SFP modules for fiber
optic signaling (see Table 2) and many 3
rd
party MSA compatible modules can be used as well.
NOTE:
MSA transceiver (transmit and receive) modules may be used with the FN-64-CHAS but only the
transmit or receive side will be used (depending on the I/O card it is inserted into). To remain cost effective, it
is thus recommended that transmit only or receive only SFP modules are used when planning system I/O.
Model
Description
MDOPT00820
3G Video Transmitter SFP, 1310nm, For use with FN-8-IN-SFP Card
MDOPT00840
3G Video Receiver SFP, For use with FN-8-OUT-SFP Card
Table 2: Multidyne SFP Modules
1.3
Powering Up The Device
This device is not equipped with a power switch and is simply connected to the power supply adapter which is
plugged into a suitable AC power source, to power it up.
Once the device is powered it goes through the following startup sequence:
•
Reset switch is checked and if it is pressed then the Software failsafe recovery procedure is entered.
Figure 6: Video board installation example (FN-8-OUT-BNC)