Motrona DS230 Series, Safety Manual

Page: 72 / 100

Ds230_03a_oi_e.doc / Jun-15 Page 72 / 100
„Control Menu“
No. Parameter Range Default
062 Input 1 Function
(assigns a control function to input „Control1“)
: 0 - 16 0
Important notes for DS240 / DS246 see chapter 7.4.1
The switching conditions (active HIGH or active LOW) can be defined by
parameter 063.
0 No function assigned
1 Release lock of output „OUT1“
[dyn]
2 Release lock of output „OUT2“
[dyn]
3 Release lock of output „OUT3“
[dyn]
4 Release lock of output „OUT4“
[dyn]
5 Release lock of output „RELAY“
[dyn]
6 Release all output locks together
[dyn]
7 Set Frequency1 (see parameter 018)
Frequency simulation of Sensor1 (see parameter000)
[stat]
[PRG]
8 Set Frequency2 (see parameter 025)
Frequency simulation of Sensor2 (see parameter000)
[stat]
[PRG]
9 Set Frequency12 (see parameter 018 und 025)
Frequency simulation of Sensor1 und Sensor2
[stat]
[PRG]
10 Freeze Frequency1
Freezes the actual encoder frequency of Sensor1
[stat]
[PRG]
11 Freeze Frequency2
Freezes the actual encoder frequency of Sensor2
[stat]
[PRG]
12 Freeze Frequency12
Freezes the encoder frequency of Sensor1 and Sensor2
[stat]
[PRG]
13 Preselection Change (see chapter 7.4.5 )
Switchover between the upper and lower switching
point. Takes effect to all outputs.
[stat]
14 Clear Drift1 (see parameter 016)
Clears the counter of position drift 1.
[dyn]
15 Clear Drift2 (see parameter 023)
Clears the counter of position drift 2
[dyn]
16 Clear Drift12 (see parameter 016 und 023)
Clears both counters (position drift 1 and 2)
[dyn]
[dyn] = dynamic function if a rising edge appears at the input
[stat] = static permanent function
[PRG] = function only in the “Programming Mode” active

If the commands „Set Frequency“ and „Freeze Frequency“ are activated simultaneously by
the external control inputs, the function „Set Frequency“ has priority.

The safety function of the unit cannot be guaranteed before the commissioning is completed.