Motrona DS230 Series, Safety Manual

Page: 67 / 100

Ds230_03a_oi_e.doc / Jun-15 Page 67 / 100
Continuation “Switching Menu”:
No. Parameter Range Default
054 Start-up Mode
(start-up delay time window)
:
Delay time window until the monitoring function is activated. Only
useful in combination with switching mode 1 and 5 (see chapter
7.4.6 ).
To use the start-up delay, it must be assigned to an output (see
parameter 055).
The start-up delay will be activated:
a) with next power-up
b) always when after standstill a frequency is detected again
0
no start-up delay
1
start-up delay 1 second
2
start-up delay 2 seconds
3
start-up delay 4 seconds
4
start-up delay 8 seconds
5
start-up delay 16 seconds
6
start-up delay 32 seconds
7
start-up delay 64 seconds
8
start-up delay 128 seconds
9
automatically, until the value has been exceeded
for the first time (see chapter
7.4.5 )
0 - 9 0
The defined delay time window is valid for all outputs
(see parameter 055).
055 Startup Output
(assignment of a start-up delay to outputs)
:
By using a 5 bit binary code the start-up delay function can be assigned
to the outputs. Settings see below:
Output: RELAY OUT4 OUT3 OUT2 OUT1
Bit 5 4 3 2 1
Binary: 10000 01000 00100 00010 00001
Value: 16 8 4 2 1
Example:
A setting of „17“ (binary 10001) means that a start-up delay is assigned
to OUT1 and to the relay-output.
0 - 31 0

During the start-up delay no frequency monitoring resp. frequency comparison
is processed!

The setting of a start up delay time is only possible when the parameter "Switch Mode
OUT1" is 1, 2, 5 or 6. (see parameter 039 and following., marking {A})