Ds230_03a_oi_e.doc / Jun-15
Page 61 / 100
7.4.5.
Preselect Menu
This menu is used to set the switching points of the following outputs:
-
1 x relay output [X1 | RELAY OUT]
-
4 x control output [X2 | CONTROL OUT]
All settings are related to the selected basic frequency (see parameter 003) considering to the
adjusted scaling factor of the basic sensor (see chapter
).
There are two separate switching points for each output, which allows e. g. to define the limit
values for the “set-up mode” and “production mode”.
A switchover between the switching points „High“ and „Low“ can only be released by an external
command, resp. by using one of the both control inputs at terminal [X10 | CONTROL IN]. The change
will affect all outputs! Therefore the function „Preselection Change“ must be assigned to an unused
input (see chapter
/ Parameter 062 = 13). A switchover is only possible if the control input
Control1 or Control2 in the selected "Operational Mode" (Parameter 000) is available (see chapter
, et seq.).
Index „.H“ stands for „High“ and requires a higher limit value.
Index „.L“ stands for „Low“ and requires a lower limit value.
Summary of Contents for DS230 Series
Page 10: ...Ds230_03a_oi_e doc Jun 15 Page 10 100 4 3 DS236 Block Diagram 4 4 DS236 Connections...
Page 11: ...Ds230_03a_oi_e doc Jun 15 Page 11 100 4 5 DS240 Block Diagram 4 6 DS240 Connections...
Page 12: ...Ds230_03a_oi_e doc Jun 15 Page 12 100 4 7 DS246 Block Diagram 4 8 DS246 Connections...
Page 100: ...Ds230_03a_oi_e doc Jun 15 Page 100 100 12 Certificate...
