Motrona DS230 Series, Safety Manual

Page: 58 / 100

Ds230_03a_oi_e.doc / Jun-15 Page 58 / 100
7.4.3. Sensor1 Menu
No. Parameter Range Default
013 Direction1:
Important notes for DS240 / DS246 see chapter 7.4.1
Parameter to assign a direction for Sensor1
0
No changes
1
Changes the sign of the direction
This allows to reverse the direction of Sensor1 in order to adapt
Sensor1 to the direction of Sensor2.
For SIN / COS or A, B input signals, the primary direction is defined
by the signal phase shifting. With single-channel HTL signals (only
channel A) the direction can be defined by using a static signal at
the channel B input.
The direction selection affects the following outputs:
-
Analog Output
- Control Outputs
- Relay Outputs
And thus the following menus:
- preselected thresholds in the Preselect Menu (see chapter
7.4.5 )
- switching behaviors in the Switching Menu (see chapter 7.4.6 )
- analog output in the Analog Menu (see chapter 7.4.10 )
0 - 1 0
014 Multiplier1
(proportional pulse scaling factor)
:
Is used to modulate the frequencies of Sensor 1 and Sensor2.
This scaling affects only the calculation of the divergence
(see parameter 004, et seq.).
1 - 10 000 1
015 Divisor1
(reciprocal pulse scaling factor)
:
To adjust the frequencies of sensor1 and sensor2.
This scaling affects only the calculation of the divergence
(see parameter 004, et seq.).
1 - 10 000 1
When using two encoders with differing pulse rates or in case of a mechanical reduction between
both encoders, the higher frequency must be converted to the lower frequency by using the
scaling factors (see chapter
8. ).