Motrona DS230 Series, Safety Manual

Page: 68 / 100

Ds230_03a_oi_e.doc / Jun-15 Page 68 / 100
Continuation “Switching Menu”:
No. Parameter Range Default
056 Standstill Time
(delay time until „standstill“)
:
This parameter defines the delay time until the unit detects „standstill“
after detecting „frequency = 0“.
Prior condition is that both input frequencies are detected as „Zero“
(f
1, 2
= 0). From that moment, the standstill period runs off and indicates
„Standstill“ when elapsed.
0 - 9.999
(sec.)
0
057 Lock Output
(assignment of a lock-function to an output)
:
The assignment of a lock-function to an output can be adjusted by
using a 6 bit binary code as follows:
Output: (*) RELAY OUT4 OUT3 OUT2 OUT1
Bit 6 5 4 3 2 1
Binary: 100000 010000 001000 000100 000010 000001
Value:
32 16 8 4 2 1
Bits 1 to 5 are used to assign the lock function to the respective
outputs. The highest valued bit 6 (*) determines if a locked output can
be released exclusively by an external input signal (bit 6 = 0) - see
chapter
7.4.7 - or additionally by an automatic reset when “Standstill”
is indicated (bit 6 = 1).
Example:
An adjustment of 17 (binary 10001) means that a lock is assigned to
output Out1 and to the relay, which can be released exclusively by an
external input signal (see chapter
7.4.7 ).
Further the adjustment 49 (binary 110001) means that the lock-
functions of OUT1 and the relay are deleted additionally when
„Standstill“ is detected.
0 - 63 0

If a wipe signal is adjusted (Parameter 044, ff.) no self-locking function
(parameter 057) can be assigned to the respective output.

The setting of a lock output function is only possible when the parameter "Switch
Mode OUT1" is between 0 and 6. (see parameter 039 and following., marking {S})