Preparing Your Radio for Use
This section provides simple instructions to prepare your radio for use.
2.1
Charging the Battery
Prerequisites:
WARNING:
To avoid a possible explosion:
• Do
not
replace the battery in any area labeled
hazardous atmosphere
.
• Do
not
discard batteries in a fire.
When and where to use:
Motorola Solutions-approved battery shipped with your radio is uncharged.
Prior to using a new battery, charge it for a minimum of 16 hours to ensure optimum capacity and
performance. For a list of Motorola Solutions-authorized batteries and chargers available for use with
your radio, see
.
NOTICE:
When charging a battery attached to a radio, the radio must be turned off.
Procedure:
To charge the battery, place the battery (with or without the radio) in a Motorola Solutions-
approved charger.
The LED on the charger indicates the charging progress, see the
Charger User Guide
.
2.2
Attaching the Battery
If your radio is preprogrammed with volatile-key retention, the encryption keys are retained for
approximately 30 seconds after battery removal. Check with your dealer or system administrator for
more information.
NOTICE:
User is notified if radio detects non-Motorola Solutions battery upon powering up, charging, or
removing from the charger. This feature is applicable for IMPRES and Non-IMPRES battery.
When the radio is attached with the non-Motorola Solutions battery, a tone sounds, display
shows
Unknown Battry
temporarily and battery indicator is not shown in the radio display.
Battery menu screen displays
Unknown Battry
permanently and IMPRES battery information
is not shown on the radio display.
Procedure:
1
Slide the battery into the radio frame until the side latches click into place.
2
To remove the battery, turn the radio off. Squeeze the release latches at the bottom of the
battery until the battery releases from the radio.
MN003602A01-AF
Preparing Your Radio for Use
15
