1.2
Radio Care
Proper radio usage and care ensure efficient operation and long life of the product.
CAUTION:
Use the radio according to the following recommendations and warnings.
• Your radio casing has a vent port for pressure equalization in the radio. Never poke this vent
with objects such as needles, tweezers, or screwdrivers. Poking the vent could create
leak paths into the radio and the radio submergibility will be lost.
A
• Never obstruct or cover the vent port, even with a label.
• Ensure that no oily substances come in contact with the vent port.
• Your radio is designed to be submerged to a maximum depth of 6 feet and maximum time of
2 hours. Exceeding either maximum limit may result in damage to the radio.
• Elastomer seals used in portable radios age with time and environmental exposure. To
ensure the waterseal integrity of the radio, Motorola Solutions recommends that radios be
checked annually as a preventive measure. The disassembly, test, and reassembly
procedures along with necessary test equipment are available in the
Service Manual
.
• If the radio battery contacts are exposed to water without the battery attached, dry and clean
the radio battery contacts before attaching a battery to the radio. Turn the radio over with the
battery contact facing down and shake the radio so any trapped water can escape. A short
circuit of the contacts could occur if they are not dried properly.
• If the radio has been submerged in water, shake the radio to remove any water that is
trapped inside the speaker grille and microphone port. Otherwise, the water decreases the
audio quality of the radio.
• If an accessory is not attached to the radio, ensure that the accessory connector cover is
attached to the radio side accessory connector.
• If the radio is submerged or exposed to a high force water spray, such as from a hose,
remove the accessory or accessory connector cover immediately and ensure that no water
is forced into the accessory connector/radio interface. Rinse and dry the area and re-attach
the accessory or accessory connector cover if leakage occurs.
• If the radio is exposed to a corrosive environment, such as salt water or corrosive gases or
liquids, rinse and clean the radio immediately to prevent damage to radio materials,
especially plated surfaces. Remove the battery and the antenna before cleaning.
MN003602A01-AF
Read Me First
11
