Page 35
FIG.1.6
Operator Side
Locking Screw
SYSTEM
Autofold Pro
To allow for manufacturing tolerances, the squareness of the Vacuum Table Assembly is
controlled by the location plate on the inside of the main frame on the operator side of the
machine.
Use the following procedure to check & adjust the Loading Table squareness:-
Open the Input Roller gap fully by releasing the Locking Screw using a 4mm hexagon key to
move it down towards the Vacuum Table. (See FIG.1.6 below).
Place a Test Sheet on the Vacuum Table with its Lay Edge against the Fixed Side Lay & slide
it through the open Input Rollers until the lead edge just becomes visible.
Do not use damp, bent, buckled or damaged test sheets.
It should be possible to visually check the parallel alignment of the lead edge of the sheet
with the Upper Input Roller. (See FIG.1.8).
1.6.
1.7.
1.8.
WARNING.
Equal
=
Side Lay (Manifold)
Input Roller
Paper
Lead Edge of Test Sheet
Equal
=
Fixed
Upper
FIG.1.8