Page 3
SYSTEM
Pan head and Cross-head countersunk screws all have metric Taptite threads and
Pozi-drive recesses. Use No.2 point Pozidriv or Supadriv drivers for all screws M4 &
above, and No.1 point drivers for M3 & below.
Warning
This machine is heavy care should be taken
when handling
iii ........Identification
iv ........New Machine Preparation
For general identification of areas of the machines, the following
terms are used:-
Operator side (control panel facing)
Rear of machine (opposite to control panel)
Delivery end (to the left of the operator side)
Feeder end ( on your right )
Remove all packaging materials
All metal parts, including the folding rollers have a protective coating
And any excess should be removed.
Connect the power cable to the mains supply.
The machine
requires 230V 50Hz 10 Amps.
Turn the fold rollers by hand to ensure they rotate freely.
Switch on the machine and check that all functions operate.
Set up the machine to fold paper and check that the machine feeds
and folds correctly.
WARNING
WORK SHOULD BE CARRIED OUT BY A TRAINED AND COMPETENT
ENGINEER AND ALL SAFETY PROCEDURES SHOULD BE ADHERED
TO.
SWITCH OFF MAINS POWER BEFORE COMMENCING.
DO NOT USE PHILLIPS DRIVERS - THESE WILL DAMAGE THE SCREWS
& MAY SLIP, CAUSING DAMAGE OR INJURY.
Autofold Pro