Page 13
SYSTEM
SECTION B
Removal of Feed Bed unit
1.
Remove the top panel of the Feed Bed as previously explained.
2.
3.
4.
Open the Lay side column and remover the set screw from the top of the gas strut eye
5.
Open the Operator column and loosen the support knob.
6.
With access to the fan control board remove the connections to the rest of the
machine.
Now remove the Latches on either side of the bed near the operator and lay doors.
This requires unscrewing the two pan head screws diagonally opposite each other as
shown below.
Support the feed bed from underneath and remove the support shaft that holds the
gas struts in place. (CAUTION, removal of shaft will cause Feed Bed to pivot. Ensure
Bed is supported before removal of shaft).
7.
With the Shaft removed you can now slide the bed out of the location plates and lift
the bed free from the machine
To replace is the reverse procedure. Use the support knob to tighten and fix the
gas struts into place. (To align the Bed correctly see page 35).
Autofold Pro
Latch
Unscrew
Pan Heads