Moog CURLIN INFUSION PainSmart, User Manual

Page: 119 / 141

113
inches above the pump.
c. Connect the downstream side of the administration set to a volumetric accuracy
measurement device (i.e. a calibrated scale or burette) at the same level as the pump +/- 2
inches.
EPI IV
Pre Rx: Pre Rx:
UNITS: mL UNITS: mg
Admin Rt: EPI CONC: 1 mg/mL
Load Dose: 0.0 mL Admin Rt: IV
MedLMTS
™
: OFF Load Dose: OFF
NEXT? YES MedLMTS
™
: OFF
NEXT? YES
Prescription: Prescription:
BAG VOL: 100 mL BAG VOL: 100 mL
RATE: 0 mL/hr RATE: 0 mg/mL
Pt Bolus: 9.9 mL Pt Bolus: 9.9 mg 1
BOLS INT: 1 min BOLS INT: 1 min
#BOLS/hr: 1 #BOLS/hr: 1
DONE? YES DONE? YES
d. Program one of the following Infusions based on the default in the pump:
e. Start the pump by pressing RUN button.
f. Press the BOLUS key to start a bolus.
g. When the 9.9 mL infusion is over, observe the amount volume infused as measured on the
measurement device. Passing measurement is: 9.4 g to 10.4 g (9.4 mL to 10.4 mL).
h. When “INFUSION COMPLETE” displays verify that the audio alarm beeps and that the
green LED
is flashing.
3. CHECK ALL SAFETY SYSTEMS:
Repeat the same Rx as above. Start the infusion and press the BOLUS key to start a bolus dose.
a.
Low Down Stream Occlusion
- Go to the Option screen and confirm that the Down
Occlusion level is set to LOW. Start the infusion and while the pump is running pinch off
or close the down stream side of the administration set. Confirm the pump goes into Down
Occlusion alarm. Open or clear the down stream occlusion and confirm the pump resumes
infusion.
b. High Down Stream Occlusion - Go to the Option screen and change the Down
Occlusion level to HIGH. Again pinch off or close the clamp on the down-stream side
of the administration set. Confirm the pump goes into Down Occlusion. Open or clear the
down stream occlusion and confirm the pump resumes infusion.