ECO‑DC series
49
BE-801372.01-Digital_clocks_manual-221114
©MOBATIME
4x Ø
5,2
60
10
0
A
B
280–440
80
60
80
Ø
35
7.1.4
Mounting
7.1.4.1
Single sided
•
Drill two anchoring holes into the wall of a diameter adequate to accommodate supplied wood‑type
screws with dowels. See the
assembly diagram for appropriate hole spacing.
•
Mount the hanging screws with the dowels to drilled holes in a way that the heads of the screws
are approx 3–5 mm from the wall.
•
Shorten all the incoming cables appropriately.
•
Mount the wide 2‑pin connector to the incoming powering cable.
•
Mount the 2‑pin connector to the synchronization signal cable or crimp the RJ45 modular connector
to the incoming Ethernet cable.
•
Connect all interconnecting cables into the corresponding connectors in the clock's back side
recess.
•
Hang the clock to the hanging screws.
•
If the clock has to be tilted down slightly, cut the supporting element on the bottom of the back
side accordingly.
7.1.4.2
Double sided
•
The double sided clock consists of two parts, one serving as the Master display (this
one encompasses the terminal to connect powering voltage and synchronization source),
and the other serving as the Slave display (with the terminal for the connection of interconnecting
cable). Both clock parts are interconnected via a 10‑core flat cable.
•
Connect the 10‑core interconnecting cable into the corresponding plug on the clock
control PCB of the slave display.
ď
The cable must never be connected or disconnected when power of the Master part is on.
•
Drill four anchoring holes into the ceiling (or wall) of a diameter adequate to accommodate supplied
wood-type screws with dowels.
•
Interlace the incoming cables through the suspension pipe. Faster the ceiling suspension (or wall
bracket) to ceiling (or wall) using 4 wood screws of 5 mm diameter.
•
Interlace the incoming cables through the pipe insert on the anchoring plate. Slip‑on the plate onto
suspension in a way that the screws fit into the upper groove on the pipe insert. Fix the connection
by tightening the screw using an Allen key.
•
Hang the Slave display of the clock to one side of the anchoring plate.
•
Shorten all the incoming cables appropriately.
•
Mount the wide 2‑pin connector to the incoming powering cable.
•
Mount the 2‑pin connector to the synchronization signal cable or crimp the RJ45 modular connector
to the incoming Ethernet cable.
• Connect all the interconnecting cables into the corresponding connector in clock back side
recess.
•
Hang the Master display of the clock to the anchoring plate.
•
If the clock has to be tilted down slightly, cut the supporting element on the bottom of the back
side accordingly.
•
Loosen the screws on the suspension using the Allen key, and lift the clock into the suspension
in a way that the screws fit into the lower groove on the pipe insert. Secure the attachment
by tightening the screw using Allen Key.
Note: During the disassembly first withdraw the clock, and suspend the suspension on the upper
groove at the pipe insert.
Summary of Contents for DSC. 250.4
