Bellman Alarm clock model BE1340
Instruction manual Bellman Alarm clock (GB)
Bellman Alarm clock, model BE1340, is a table top clock with extra functions:
Snooze function.
Wake-up alarm with a sound signal with increasing intensity and volume and/or clear flashes.
The number of flashes and their interval is automatically adjusted depending on the surrounding light
Two Bellman Visit Bed-shakers (accessory) can be connected to wake you up through vibrations.
The clock face is illuminated for wake-up and also when the snooze button is pressed.
The alarm clock can be connected to a telephone outlet to signal for incoming calls, and also to an external
trigger.
It has a built-in, rechargeable back-up battery that is activated upon power failure or when the clock is not
connected to the mains supply.
To ensure correct handling, please read this manual before using this equipment for the first time.
Getting started…
1) Power supply:
Connect the power adapter to the inlet (12) marked DC IN 7.5V on the backside of the alarm clock.
Let the unit be connected for 24 hours initially to allow the back-up battery to fully charge. This
will increase the life span of the battery. Normally, 16 hours is required to fully recharge an empty battery.
Please note! Use only the attached power adapter type G075040D25.
The rechargeable battery (NiMH) is activated when the clock no longer is powered via the power adapter.
A fully charged battery lasts approximately one week of normal usage, but it is recommended to always leave the unit
connected to the adapter with the mains switched on.
Power supply indicator (1)
Power supply indicator (1) shines with a constant green light during normal usage when the power adapter is connected.
... flashes with green light during power failure or when the power adapter is not connected.
... flashes with a red light when the back-up battery is low and needs to be recharged.
2) Adjusting time
Use the knob (11) on the back of the unit to set the correct time.
3) Adjusting time for wake up
a) Set the time for wake up using the knob (10) on the back of the unit.
b) The wake-up alarm is turned on or off using the knob (5) marked ‘ALARM’ on the right side of the unit.
c) When the alarm is on, the snooze button (4) is lit.
Please note! Only available when the unit is connected to the mains supply.
d) Wake-up can happen through sound, flashes and vibrations from the bedshaker (accessory). The sound and the flashes are
activated through the switches marked (7) and (9) on the back of the unit. Set these in desired mode.
Wake up
Wake up happens through a sound signal with increasing intensity and volume, with clear and distinct flashes and through
vibrations if the Bellman Visit Bed-shaker, model BE1270, (accessory) is connected. If the alarm is not turned off within 30
minutes, it will stop automatically. Upon wake-up, the clock face is illuminated. The snooze function, which turns the alarm
on again after 3.5 minutes, is obtained when the snooze button (4) is pressed down. The snooze button will then flash (if the
unit is connected to the mains supply).
Summary of Contents for BE1340
Page 4: ......
