98
BE-801372.01-Digital_clocks_manual-221114
©MOBATIME
in a way that the screws fit into the upper groove on the pipe insert. Fix the connection by tightening
the screw that using an Allen key.
• Interlace the incoming conductors thought the opening located next to the terminal board
and connect the conductors to the terminal board on the anchoring plate.
•
Mount the connectors to the cable of the temperature sensor, to the keyboard cable, Ethernet cable
or to the RS 485 interface connectors if these are used.
• Place the display part of the clock to the anchoring plate, at a position which is opposite
to the terminal board, and suspend this part onto the upper springs. Interlace the 10‑core
interconnecting cable through the lower opening which finds itself at the closest to the terminal
board on the anchoring plate.
•
Care should be taken when placing the cables between the frame edge and the
•
Connect the 10‑core interconnecting cable and the interconnecting cables into the corresponding
plugs on the clock control PCB.
•
Push the temperature sensor connector, the keyboard connector, Ethernet connector or the RS 485
jacks into the corresponding terminals on the control PCB.
ď
Be careful not to swap the terminals.
Check the markings of the jack‑plugs.
•
Put the control part of the clock opposite to the anchoring plate and suspend it onto the upper
springs. Care should be taken when placing the cables between the frame edge and the anchoring
plate, so as not to nip them. Snap the clock in onto the springs by pushing on the lower part
of the frame
•
Check whether the anchoring plate on the sided fits exactly into the grooves established in both
parts of the digital clock (these must be pushed against each other in a way to mask the anchoring
plate ‑ after placing the parts the plate shall not be seen).
• Remove the blind cap from the opening on the both lower sides of clock.
•
Insert Allen key into the opening on the lower side of the clock. Turn the key softly in anticlockwise
direction. The frame catch will snap in. Secure both parts of the clock.
• Replace the blind cap
•
Loosen the screws on the suspension using Allen key and lift the clock into the suspension in a way
that the screws fit into the lower groove on the pipe insert. Secure the attachment by tightening the
screws using the Allen key.
•
To loosen the frame catch use the reverse procedure (turn clockwise).
Note: During the disassembly first withdraw the clock, and suspend the suspension on the upper
groove at the pipe insert.
7.6.4.3 Panel flush mounting DA.18
•
Prepare opening for clock. Minimal dimensions should be W 126 x H 136 mm.
•
Dismount front part of clock (frame with plexiglass and electronics) – it is fixed to rear part of clock
by magnets.
•
Pull the cables through the rubber grommet and insert the rear part of the clock to the prepared
opening.
•
Pull fixing ″Z″ profiles one by one through rectangular openings on the sided of the rear part and fix
them using supplied screws M4x12 DIN 7985. Fix the clock in panel using these mounting screws
with appropriate torque.
•
Mount the part of clock back.
Summary of Contents for DSC. 250.4
