DA series
99
BE-801372.01-Digital_clocks_manual-221114
©MOBATIME
7.6.4.4
Panel mounting accessible from the rear side DA.18
•
Prepare opening for clock. Minimal dimensions should be W 126 x H 136 mm.
•
Dismount front part of clock (frame with plexiglass and electronics) – it is fixed to rear part of clock
by magnets.
•
Insert rear part of clock to the prepared opening and mount profiles "L" on the sided of the clock using
M4x12 DIN 7985 screws. Fix the clock into the opening using 4 mounting screws with appropriate
torque.
•
Pull the cables through the rubber grommet, mount connectors on the cables and connect them
to the corresponding terminals on the clock control PCB.
•
Mount front part of clock back.
7.6.4.5 Wall flush mounting DA.18
•
Put a paper pattern on the wall. According to pattern drill wall plug holes Ø8 mm to a depth
of 100 mm and mark the corners of the mounting opening.
•
Prepare opening for the clock. Minimal dimensions W 131 x H 141 mm, depth 55 mm.
•
Insert the dowels to the mounting holes Ø8 mm.
•
Dismount front part of clock (frame with plexiglass and electronics) – it is fix to rear part of clock
by magnets.
•
Pull the cables through the rubber grommet. Insert the rear part of the clock into the opening and fix
it slightly using 4 screws DIN 7982 ST3,5.
•
Align the clock with the wall surface using 4 screws M5x12 DIN7985 and fix it using 4 screws
DIN 7982 ST3,5 using appropriate torque.
•
Mount connectors on the cables and connect them to the corresponding terminals on the clock
control PCB
•
Mount the front part of clock back.
7.6.4.6
Table mounting DA.18
This version of clock is primarily designed as free-standing on 4 rubber foot. The clock can also
be securely fixed to one place on the table, follow these steps:
•
Using screwdriver dismount 4 rubber legs on the bottom of the clock.
•
Using your fingers dismount round bottom cover
•
Choose some place for the clock on the table. In the middle of this place make a hole for cables.
• Put the cover on the table so that the central hole of the cover in concentric with the hole
in the table.
•
Fix the cover to the table with the appropriate screws in locations 3 holes in the cover.
• Pull the cables through the hole in the cover and table and mount connectors on the cables
and connect them to the corresponding terminals on the clock control PCB.
• Clip the clock on the cover.
Summary of Contents for DSC. 250.4
