126
BE-801372.01-Digital_clocks_manual-221114
©MOBATIME
7.10.4
Mounting
7.10.4.1
Single sided
•
Assemble the wall mounting if delivered disassembled.
•
Drill appropriate number of anchoring holes in the wall for wood‑type screws of 6 mm diameter.
Use the mounting console as a template.
•
Mount the console on the wall and put it into a fully tilted out position.
•
Shift the clock body into the flipped out console arms and fix it by tightening the Allen
screws.
•
Dismantle the back connector cover on the clock body; the cover incorporates gap with sealing
for passage of cables in the inside of the clock.
•
Arrange all cables to appropriate length and connect them to appropriate terminals on the PCB;
see the description of the connectors and observe the correct polarity where necessary.
•
Fix the cables with the holder in correct positions in order to maintain regular spacing
between the cables in the area of passing through sealing; use appropriate force to not to damage
the cables insulation.
•
Configure the position of DIP switch according to used synchronization signal (applies only for DCF,
MOBALine, polarized impulse line or IRIG‑B)
•
Mount back the connector cover.
•
Tilt the clock into vertical position and fix the position of the console.
7.10.4.2
Double sided
•
The double side display consists of Master (control part) and Slave (display part),
•
The display is delivered as a one unit (both parts mounted on the console), Master and Slave parts
are marked by labels.
•
Remove the bottom cover from the console (M4 screws) first, bottom cover is attached
to the console by steel wire (captive cover).
•
Unscrew four locking screws placed on top of the console and put both parts into fully tilted out
positions.
•
Dismantle the back connector cover on the Master part; the cover incorporates gap with sealing
for passage of cables into the clock.
•
Loosen the cable fixing bar and disconnect the Master‑Slave connecting cables – power cable
marked by 230 VAC, etc.
•
Release four Allen screws on back side of both clocks and take out the both clock parts
from the console.
•
Drill appropriate number of anchoring holes in the wall for wood‑type screws of 10 mm diameter.
Use the mounting console as a template.
•
Push all incoming cables (power, temperature, synchronization) through the upper tube
of the console and through the oval hole, then mount the console on the wall.
•
Put both sides into a fully tilted out positions.
•
Hang the Slave part on one side of the console and tighten four screws on the back side.
Summary of Contents for DSC. 250.4
