When turning from “ACC” to “LOCK”
First, set the gearshift lever to the “P” (PARK) po-
sition, and then slowly turn the ignition switch to
the “LOCK” position while pressing it.
NOTE
l
The ignition switch cannot be turned to the
“LOCK” position unless the gearshift lever
is in the “P” (PARK) position.
CAUTION
l
Do not turn the ignition switch to the
“LOCK” position while driving. The
steering wheel will be locked, causing loss
of control.
l
If the engine is stopped while driving, the
brake servomechanism will cease to func-
tion and braking efficiency will deterio-
rate. Also, the power steering system will
not function and it will require greater
manual effort to operate the steering.
CAUTION
l
Do not leave the ignition switch in the
“ON” or “ACC” position for a long time
when the engine is not running, doing so
will cause the battery to be discharged.
l
Do not turn the ignition switch to the
“START” position when the engine is
running, doing so could damage the start-
er motor.
Warning activation
E00305900587
In order to prevent vehicle theft or the accidental
operation of the keyless operation system, the buz-
zer and the display on the information screen in the
multi-information display are used to alert the driv-
er.
If a warning is activated, always check the vehicle
and the keyless operation key. The warning is also
displayed if there is a fault in the keyless operation
system.
If any of the following warnings are activated,
please contact a MITSUBISHI MOTORS Author-
ized Service Point.
There is a fault in the keyless opera-
tion system.
The battery in the keyless operation
key has worn out.
In the following cases, a warning is activated, but it
can be cancelled if the correct actions are followed.
l
The ID codes for the keyless operation key
and the vehicle do not match.
You could be carrying another key-
less operation key with a different
code, or the keyless operation key
could be outside the operating range.
Refer to “Keyless operation key
take-out monitoring system” on
l
Even though you press the driver’s or front
passenger’s door lock/unlock switch, the
doors are not locked.
Refer to “Key lock-in prevention
Refer to “Door ajar prevention sys-
Refer to “Ignition switch turn-off re-
Keyless operation key take-out monitoring system
E00308000286
When the vehicle is parked with the ignition switch
in any position other than “LOCK” (PUSH OFF),
if you close the door after opening any of the doors
and taking the keyless operation key out of the ve-
hicle, a warning displays and the buzzer sounds 4
times.
Locking and unlocking
1-12
OCZE14E3
1
Summary of Contents for LANCER EVOLUTION
