How to use the rear-view camera
When you place the gearshift lever in the “R” posi-
tion with the ignition switch in the “ON” position,
the view behind the vehicle will automatically ap-
pear on the screen of the MITSUBISHI Multi
Communication System (MMCS) or the DISPLAY
AUDIO. When you move the gearshift lever to any
other position, the screen will return to its original
indication.
CAUTION
l
The rear-view camera has a special lens
that can make objects shown on the
screen appear to be closer or further
away than they actually are.
NOTE
l
Because the rear-view camera has a special
lens, the lines on the ground between parking
spaces may not look parallel on the screen.
l
In the following situations, the screen indica-
tion may be difficult to see. There is no ab-
normality.
• Low light (nighttime)
• When the light of the sun or the light
from a vehicle’s headlamps shines direct-
ly into the lens
l
If the camera is hot and is then cooled by
rain or a car wash, the lens can mist up. This
phenomenon does not indicate a malfunc-
tion.
l
It is not possible to fully see obstacles when
the lens is dirty. If the lens becomes conta-
minated by water droplets, snow, mud or oil,
wipe off the contamination, taking care not
to scratch the lens.
l
Please observe the following cautions. Ignor-
ing them could lead to a camera malfunction.
• Do not subject the camera to physical
shock.
• Do not apply wax to the camera.
• Do not splash the camera with boiling
water.
• Do not disassemble the camera.
Reference lines on the screen
Reference lines and upper surface of the rear
bumper (A) are displayed on the screen.
l
Red line (B) indicates approximately 50 cm
behind the rear bumper.
l
Two Green lines (C) indicate approximately
20 cm outside of the vehicle body.
l
Short transverse lines (1 to 3) indicate dis-
tance from the rear bumper.
Check surroundings for safety.
1- Approximately at the rear edge of the rear
bumper
2- Approximately 100 cm
3- Approximately 200 cm
NOTE
l
When the vehicle is tilting because of the
number of people in the vehicle, the weight
and positioning of luggage, and/or the condi-
tion of the road surface, the lines in the view
from the rear-view camera may not be accu-
rately positioned relative to the actual road.
The reference lines for distance and vehicle
width are based on a level, flat road surface.
In the following cases, objects shown on the
screen will appear to be farther off then they
actually are.
Starting and driving
4-44
OCZE14E3
4
Summary of Contents for LANCER EVOLUTION
