Mitsubishi MOTORS LANCER EVOLUTION, Owner'S Manual

Page: 257 / 330

CAUTION
l
The tyre sealant can cause health damage
if swallowed. If you accidentally swallow
it, drink as much water as possible and
immediately consult a doctor.
l
If the tyre sealant gets in your eyes or on
your skin, rinse with lots of water. If you
still sense an abnormality, consult a doc-
tor.
l
Consult a doctor immediately if any aller-
gic reactions occur.
l
Do not allow children to touch the tyre
sealant.
l
Do not breathe in the vapours of tyre
sealant.
NOTE
l
The tyre sealant cannot be used in any of the
situations listed below. If any of these situa-
tions occurs, please contact a MITSUBISHI
MOTORS Authorized Service Point or an-
other specialist.
• The tyre sealant’s expiry date has passed.
(The expiry date is shown on the bottle
label.)
• More than one tyre is punctured.
• The puncture hole has a length or width
of 4 mm or more.
• The tyre is punctured in the side wall (A),
not in the tread (B).
• The vehicle has been driven with the tyre
almost completely flat.
• The tyre has completely slipped over the
wheel rim and has come off the wheel.
• The wheel is damaged.
l
Use the tyre sealant only at ambient tempera-
tures of -30 °C to + 60 °C.
l
Effect an emergency repair without pulling
out the object (nail, screw, etc.) that is stuck
in the tyre.
l
Do not use the tyre sealant if the tyre has
been damaged by being driven when insuffi-
ciently inflated (e.g. bumps, cuts, cracks etc.
on the tyre).
l
Wipe tyre sealant off the paintwork immedi-
ately with a damp cloth.
l
Immediately wash clothes contaminated with
tyre sealant.
Before repairing a tyre, first stop your vehicle in a
safe, flat location.
1. Park the vehicle on level and stable ground.
2. Set the parking brake firmly.
3. On vehicles with M/T, turn the ignition
switch to the “LOCK” position, move the
gearshift lever to the “R” (Reverse) position.
On vehicles with Twin Clutch SST, move
the gearshift lever to the “P” (PARK) posi-
tion, turn the ignition switch to the “LOCK”
position.
4. Turn on the hazard warning flashers and set
up a warning triangle, flashing signal lamp,
etc., at an adequate distance from the vehi-
cle, and have all your passengers leave the
vehicle.
5. Take out the tyre sealant bottle and the com-
pressor.
6. Shake the tyre sealant bottle well.
For emergencies
6-07
OCZE14E3
6