Mitsubishi MOTORS LANCER EVOLUTION, Owner'S Manual

Page: 55 / 330

6. Any of the following operations can be used
to terminate the system settings change
mode.
• Releasing the windscreen wiper and
washer switch.
• Closing the driver’s door.
• Inserting the key into the ignition
switch.
• Placing the lamp switch in any posi-
tion other than “OFF”.
• Allowing 30 seconds to pass without
making any changes to the settings.
• The ignition switch is put into the
“LOCK” (PUSH OFF) position. (ve-
hicles with the keyless operation sys-
tem)
NOTE
l
If anything with regard to making changes to
the security alarm system settings is hard to
understand, please consult your
MITSUBISHI MOTORS Authorized Service
Point.
l
Avoid leaving valuable items inside the vehi-
cle even when the security alarm system has
been set to the “active” mode.
Setting the system
E00301700721
Follow the procedure below to set the system to the
system armed mode.
1. Turn the ignition switch to the “LOCK” po-
sition. If you started the engine with the key,
remove the key from the ignition switch.
2. Exit the vehicle and close all of the doors,
the trunk lid and the bonnet.
3. Press the LOCK switch (A) on the remote
control switch of the keyless entry system or
the keyless operation system, the driver’s or
front passenger’s door lock/unlock switch
(B) in order to lock all the doors.
Except for vehicles with the keyless operation system
Vehicles with keyless operation system
Driver’s and front passenger’s door lock/unlock switches*
By locking the vehicle using the keyless en-
try system or the keyless operation function,
the system preparation mode is activated.
The buzzer makes an intermittent beeping
sound and the security indicator (C) in the
audio panel blinks for confirmation.
Locking and unlocking
1-31
OCZE14E3
1