C0210101-07-16-EN
19
1
DOCUMENTATION
In addition to this manual, the following documents are delivered with the unit:
declaration of conformity
technical bulletin
dimensional and lifting drawings
cooling circuit/hydraulic diagrams
wiring diagrams
manual of the electronic controller
maintenance handbook
Before carrying out any operation, make sure that you have read and understand all the documents in the list.
2
GUARANTEE
2.1 Summary of the terms of the guarantee
The equipment supplied by Climaveneta is guaranteed for 12 months from the date of initial start-up but not more than 18 months from the date of
invoicing. Date of initial start-
up is considered as that on the appropriate “Start-up Form” contained in the “Machine maintenance logbook” fully filled
in and promptly sent to Climaveneta.
The guarantee is valid only if the installation regulations (not only those issued by Climaveneta but also those dictated by current practice) have
been respec
ted, and if the “Start-up Form” has been fully filled in and sent to Climaveneta, for the attention of the After-Sales Service.
The guarantee covers flaws and defects reported within eight days of their being found. Furthermore, the guarantee will hold only on the condition
that the client suspends using the equipment as soon as a defect is detected.
The guarantee is considered valid only if the initial start-up was carried out by an authorised Service Centre.
The guarantee is valid if regular maintenance o
f the equipment has been properly recorded in the “Machine maintenance logbook” located inside
the control panel.
The guarantee covers replacement of parts which are found to be faulty.
Climaveneta shall not be liable for any costs of handling on the site (i.e., for cranes, dismantling pipes, etc. ...) required to replace instruments such
as compressors, heat exchangers, fans, etc. ..., nor for travel and accommodation for technicians for operations in the place of installation.
2.2 Receipt of the unit
When the unit is received the client must check that there is no evident damage and no parts are missing. Otherwise, a claim for damages or non-
delivery must immediately be sent to the shipper, reporting conditional acceptance on the bill. If the damage is conspicuous, a photographic record
must also be forwarded.
2.3 Performance of Climaveneta units
Climaveneta units are factory tested according to strict internal procedures. Performance tests can only be carried out on the system if the same
conditions found in the test rooms are reproduced and maintained (the same constant load, temperature and flow rates to the heat exchangers).
2.4 Manual reset of the alarms
Warn a technician of any alarm that may have appeared on the unit.
If an alarm should go off, the unit must not be reset manually until the
cause has been checked out and removed. Repeated manual resets can render the guarantee null and void.
2.5 Useful life
In normal operating conditions, the unit is expected to have a lifetime of 10 years if it is properly serviced as described in chapter 9. After that
period, the unit should be overhauled by technicians authorised by Climaveneta.
3
SAFETY REGULATIONS
3.1 Foreword
This product is a complex machine. During installation, operation, maintenance and repairs, people and objects might be exposed to risks
associated with certain conditions or components such as, but not limited to: refrigerant, oils, moving mechanical parts, pressure, heat sources,
electrical power. Each of these elements might result in damage to objects and possibly serious personal injury or even death. The people who
operate the product have the obligation and responsibility to identify and recognise dangers and to protect themselves and always proceed in
safety.
This product and the relative documents, including this manual, are intended for people who have received independent training and have been
taught how to work in a correct and safe manner. Before handling this equipment in any way, it is essential that the personnel involved have read
and understand all the manuals and all the other reference material. The personnel must also be familiar with and observe the standards that apply
to the work in hand.
Climaveneta S.p.A. and its TECHNICIANS (as described in this manual) decline all responsibility for non-compliance with safety
regulations that were in force at the moment of installation.
3.2 Definitions
Owner
: Legal representative of the company, a body, or a natural person who owns the plant where the Climaveneta unit is installed and is
responsible for checking compliance with all the safety rules in this manual and the national regulations in force.
Installer:
Legal representative of the firm that the owner has put in charge of positioning and connecting hydraulically, electrically, etc. the
Climaveneta unit to the plant: he/she is responsible for the handling and correct installation in conformity with what is indicated in this manual
and the national regulations in force.
Operator:
Any natural or legal person who has effective control over the technical operation of the equipment and air-conditioning systems. A
member state of the European Community can, in very specific circumstances, consider the owner responsible for the obligations of the
operator.
Maintenance person
:The person authorised by the owner to carry out on the Climaveneta unit all operations of regulation and checking
expressly indicated in this manual, and which must be strictly followed. His/her work will be limited only to what is clearly allowed.
Technician:
The person authorised directly by Climaveneta to carry out all operations of ordinary and extraordinary maintenance. He/she will
also carry out all regulations, checks, repairs and replacement of parts that should become necessary during the life of the unit itself. Outside
Italy and those countries where Climaveneta and its subsidiary are not directly present, the Climaveneta agent is personally responsible for
acquiring a suitable number of Technicians proportional to the area and to the business.
