MitraStar Movistar GPT-2541GNAC, User Manual

Page: 18 / 226

Chapter 2 Device Info 18
2.2 WAN Info
Click Device Info > WAN to open this screen which lists the Router’s WAN connections and their
status.
Figure 6 WAN Info
Table 4 WAN Info
LABEL DESCRIPTION
Interface This shows the name of the WAN interface. veip0 stands for a virtual Ethernet card and
is the foundation for veip0/* which are virtual WAN interfaces of the physical GPON line.
The ppp0.* indicates a PPP connection.
The number after the dot ( . ) represents the VLAN ID number assigned to traffic sent
through this connection. The number after the underscore ( _ ) represents the index
number of connections through the same interface.
(null) means the entry is not valid.
Description This is the service name of this connection.
Type This shows the method of encapsulation used by this connection (IP over Ethernet, PPP
over Ethernet, or bridging).
VlanMuxID This indicates the VLAN ID number assigned to traffic sent through this connection. This
displays N/A when there is no VLAN ID number assigned.
IPv6 This displays whether or not IPv6 is enabled on the interface.
Igmp Pxy This shows whether IGMP (Internet Group Multicast Protocol) proxy is activated or not
for this connection. IGMP is not available when the connection uses the bridging service.
Igmp Src Enbl This shows whether IGMP source enable is activated or not for this connection. IGMP
source enable has the Router add routing table entries based on the IGMP traffic.
MLD Pxy This shows whether Multicast Listener Discovery (MLD) proxy is activated or not for this
connection. MLD is not available when the connection uses the bridging service.
MLD Src Enbl This shows whether MLD source enable is activated or not for this connection. MLD
source enable has the Router add routing table entries based on the MLD traffic.
NAT This shows whether NAT is activated or not for this interface. NAT is not available when
the connection uses the bridging service.
Status This displays the connection state or Unconfigured if the interface has not yet been
configured.