MitraStar Movistar GPT-2541GNAC, User Manual

Page: 28 / 226

Chapter 3 WAN 28
To use NAT, firewall or IGMP proxy in the Router, you need to configure a WAN connection with
PPPoE or IPoE.

When a layer-2 interface is in VLAN MUX Mode , you can configure up to five WAN services
on the Router.
Figure 16 WAN Service
Table 14 WAN Service
LABEL DESCRIPTION
Interface This shows the name of the interface used by this connection.
veip0 stands for a virtual Ethernet card and is the foundation for veip0/* which are virtual
WAN interfaces of the physical GPON line. The ppp0.* indicates a PPP connection.
The number after the dot ( . ) represents the VLAN ID number assigned to traffic sent
through this connection. The number after the underscore ( _ ) represents the index number
of connections through the same interface.
(null) means the entry is not valid.
Description This is the service name of this connection.
Type This shows the method of encapsulation used by this connection (IP over Ethernet, PPP
over Ethernet, or bridging).
IP This displays the IP address the connection uses. This displays N/A when the connection
does not have an IP address.
Release Use the buttons in this column to renew, release, or connect a WAN connection. This
displays N/A for a connection with a static IP address.
Vlan8021p This indicates the 802.1P priority level assigned to traffic sent through this connection. This
displays N/A when there is no priority level assigned.
VlanMuxId This indicates the VLAN ID number assigned to traffic sent through this connection. This
displays N/A when there is no VLAN ID number assigned.
VlanTpid This field displays the VLAN Tag Protocol Identifier (TPID), a four-digit hexadecimal number
from 0000 to FFFF that the OLT adds to the matched packets.
Igmp Proxy This shows whether IGMP (Internet Group Multicast Protocol) proxy is activated or not for
this connection. IGMP is not available when the connection uses the bridging service.