MitraStar Movistar GPT-2541GNAC, User Manual

Page: 31 / 226

Chapter 3 WAN 31
3.3.1.3 WAN IP Address and DNS Server
The screen differs by the encapsulation you selected in the previous screen.
Allow as MLD
Multicast Source
This displays when you select the Bridging service type. Select this to have
the Router add routing table entries based on the MLD traffic.
Enter Service
Description
Specify a name to identify the service.
veip0 stands for a virtual Ethernet card and is the foundation for veip0/*
which are virtual WAN interfaces of the physical GPON line.
eth0 ~ eth3 represent the ethernet LAN ports 1 ~ 4.
Enter 802.1P
Priority [0-7]
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a
MAC-layer frame that contains bits to define class of service.
Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this
connection. The greater the number, the higher the priority level.
Enter 802.1Q
VLAN ID [0-4094]
Type the VLAN ID number (from 1 to 4094) for traffic through this
connection.
Select VLAN TPID Select a Tag Protocol Identifier (TPID) the Router to add it to the service’s
packets.
Network Protocol
Selection
Select IPv4 Only to have the Router use only IPv4.
Select IPv4&IPv6(Dual Stack) to let the Router connect to IPv4 and IPv6
networks an choose the protocol for applications according to the address
type. This lets the Router use an IPv6 address when sending traffic through
this connection. You can only select this for a WAN service that uses the
PPPoE or IPoE encapsulation method over the layer 2 interface.
Select
IPv6 Only to have the Router use only IPv6.
Back Click this button to return to the previous screen.
Next Click this button to continue.
Table 16 WAN Configuration: WAN Service Configuration
LABEL DESCRIPTION