MIMAKI TS3-1600, Operation Manual

Page: 156 / 206

4-38
5
Slowly shake the removed white ink cartridge more than twenty
times right and left.
• To prevent ink from leaking when you shake the cartridge, wear gloves and firmly cover
the A part of the upper surface of the cartridge and the B part of the bottom surface of the
cartridge with paper towels. Then, shake it more than twenty times right and left so that ink
flows inside the cartridge.
6
Set the white ink cartridge, and press the key.
• Nozzle cleaning starts.
• The operation after nozzle cleaning varies depending
on the LEVEL set on the Step 3.
• LEVEL1 : Go to the Step 10.
LEVEL2 : Go to the Step 9.
LEVEL3 : Go to the Step 7.
7
Remove the white ink cartridge.
• When the white ink cartridge is removed, the white ink
remaining in the machine is discharged.
• After discharging, the screen shown on the right
appears.
8
Set the white ink cartridge.
9
White ink filling starts.
• Filling time of LEVEL2 is different from LEVEL3.
(When LEVEL2 is selected, filling time becomes shorter.)
10
Perform cleaning.
• If you shake it too strong, the pack inside may be damaged and it may cause ink
leakage. Therefore, perform this carefully.
• If the remaining amount of ink is less, ink in the cartridge cannot be beaten
enough. Tilt the cartridge until it becomes vertical.
A part
(the place to stick a
needle) B part
(the slot on the
bottom)
Cover with paper towel firmly and shake ink slowly
Repeat
this
A part
L v . * > NO Z Z L E WA S H
0 3 : 0 0
The remaining time
The selected maintenance level
L v . 3 > D I S CH A RGE
0 1 : 3 0
S E T : I N K C A R T R I DGE
_ W_ W_ _ _ _
L v . 3 > F I L L I NG U P
0 0 : 3 0
L v . 3 > C L E A N I NG
0 2 : 0 0