MIMAKI TS3-1600, Operation Manual

Page: 113 / 206

3-49
To use sublimation transfer ink with more stable quality
3
Convenient use
How to shake the ink cartridge
To prevent ink from leaking when you shake the cartridge, wear gloves and firmly cover the A part of the
upper surface of the cartridge and the B part of the bottom surface of the cartridge with paper towels. Then,
shake it more than twenty times right and left so that ink flows inside the cartridge.
• If you shake it too strong, the pack inside may be damaged and it may cause ink leakage.
Therefore, perform this carefully.
• If the remaining amount of ink is less, ink in the cartridge cannot be beaten enough. Tilt the
cartridge until it becomes vertical.
• If you shake the ink cartridge too strong, it may damage the inside pack and it may cause ink
leakage. Be careful about it.
• When the cartridge is new, shake it before taking it out of bag.
• When the cartridge is in-use, be sure to wear the gloves, press waste close to the inserted
side and shake it.
• If the remaining amount of ink is less, tilt it until it becomes vertical, as you cannot shake it
enough in some cases.
• When you use MBIS, do not shake the eco case and the intermediate cartridge.
• Do not insert and pull out the intermediate cartridge as much as possible. It may cause ink
leakage.
A part
(the place to stick a
needle) B part
(the slot on the
bottom)
Cover with paper towel firmly and shake ink slowly
Repeat
this
A part