MG Gloster, Manual, Page: 82 / 264

74 75
BEFORE YOU DRIVE
High beam and low beam lamps
Push the stalk switch away from the steering wheel to change the
headlamp mode from low beam to high beam. Pull the stalk switch close
to the steering wheel to change the headlamp mode to low beam.
Note: When the head/amp mode is high beam, the “headlamp high
beam indicator lamp (blue)” on the instrument cluster will
illuminate. To shift the headlamp mode to flashing, slightly lift the
stalk switch towards the steering wheel intermittently.
Daytime running lamp
The daytime running lamp make it easier for others to see the front of
the vehicle during the daytime.
If your vehicle is equipped with the daytime running lamp, when the
ignition switch is placed in ON position, the day time running lamp will
illuminate. When the day time running lamp illuminates, the low beam,
tail lamp, position lamp and other lamps will not illuminate. When the
ignition switch is in OFF position, the day time running lamp will go out.
It is in line with the requirements in ECE R87 for daytime running lamp.
BEFORE YOU DRIVE
Wiper & washer stalk switch
Front windshield wipers and washer
Place the stalk switch to the position required.
Position 1 - : Intermittent wiping. For a vehicle equipped with an
automatic wipers, its rain sensor will detect the rainfall on the
windshield and automatically adjust the wiping frequency of windshield
wipers.
Note: Ensure the rain sensor Is free of dust, dirts and Ice.
Position 2 - LO : Low-speed wiping.
Position 3 - HI : High-speed wiping.
Position 4 - OFF : Turn off wipers.
Position 5 - : Single wiping.
lntennittent wiping/interval adjustable
If worn wiper blades cannot clear rain from the front
windshield, the forward visibility will be lowered, which
may lead to an accident. Be sure to replace worn wiper
blades in time.
For vehicles not equipped with a rain sensor, when the stalk switch is
placed in (Intermittent) position, rotate the switch to change the
wiping interval.
For vehicles equipped with a rain sensor, when the stalk switch is placed
in (Intermittent) position, rotate the switch to change the wiper
sensitivity, and adjust the wiping speed of the front wipers.