MG Gloster, Manual, Page: 221 / 264

212 213
MAINTENANCE AND SERVICE
Precautions in cold weather
To reduce the possible problems caused by the use of coolant in cold
weather, the following recommendations should be taken into
consideration:
• The standard freezing point of coolant used in the vehicle is -35"C
(the mixture ratio of coolant and water is 1 : 1 ), therefore it is
required to park the vehicle in an area that can maintain the coolant
temperature above -35"C.
• When the vehicle is used in an extremely cold area where the
temperature is lower than -35"C, a suitable proportionof coolant
based on the local temperature is recommended. (Refractometer
T10007 can be used to detect the freezing point of coolant.)
Brake Fluid
If the brake fluid level drops obviously, contact Service
Dealer for service as soon as possible.
Only new brake fluid of specified type can be used. Using
brake fluid which is used or of non-specified type may
impair the brake performance.
It is crucial to keep the brake fluid clean. If any dust
enters in the system, it may result in brake performance
decline.
Don't allow brake fluid to contact your skin and eyes, In
case of contact, rinse with plenty of water. Keep the
brake fluid out of the reach of children.
Do not allow brake fluid flowing onto the engine,
otherwise it may be ignited when the engine heats up,
causing a fire and damage to the engine.
Note: Fluid used by the hydraulic clutch also comes from the brake
fluid reservoir.
• Only the brake fluid that conforms to the DOT4 specification
can be filled in the master cylinder of the brake. Do not use
brake fluid of other types.
• If the brake fluid contacts the paint, it will cause damage to the
paint. Wipe clean immediately and rinse with clean water.
MAINTENANCE AND SERVICE
Check and RefiII
Check and Refill
Be sure to check the brake fluid level after the vehicle is parked on a flat
ground and the system is in cold state. The brake fluid level is visible on
the reservoir, and the normal level should be between the "MAX" (the
maximum amount) and "MIN” (the minimum amount) marks. If the level
drops to the "MIN” mark, clean the area around the fluid refill cap and
rotate the reservoir cap counterclockwise to remove it. Refill the
specified new brake fluid to the level between "MAX" and "MIN", then
replace the reservoir cap.
If the level is lower than the "MIN" mark, "Brake System Warning Lamp
(red)" on the screen of information center will illuminate. It indicates that
the brake system is malfunctional. Figure out the reason immediately. If
your are driving, stop the vehicle carefully and immediately. Please
contact our Service Dealer for service as soon as possible. Do not
continue to drive.
Do not discard the used brake fluid randomly, so as to
avoid environment pollution.
Washer Fluid
It is dangerous to drive the vehicle while the washer
system is inoperative, be sure to check the system
before driving.
The windshield washer fluid reservoir is located in the engine
compartment. When refilling is needed, please lift the front part of the
refilling cap to add the washer fluid, and then close the cap. Refer to
"Recommended Fluid" in the General Technical Parameters section for
washer fluid specifications.
Don't use unqualified washer fluid. Don't use tap water since the
mineral substance in tap water will block the pipe or nozzle of the
windshield washer fluid.