MG Gloster, Manual, Page: 80 / 264

72 73
BEFORE YOU DRIVE
Switches on Steering Column and Steering Wheel
1 Wiper & washer stalk switch
2 Combination lamp control & direction indicator lamp stalk switch
3 Voice control, Bluetooth phone and lcall switch
4 Ignition switch and steering lock
5 Instrument cluster selection and cruise switch
Combination lamp control & direction indicator
lamp stalk switch
Shift the lighting control switch to the position as shown in the figure,
and the corresponding lamps will illuminate.
Position 1
─
OFF: Headlamps off. Daytime running lamps will
automatically illuminate after the engine is started.
Position 2 ─ AUTO: Headlamp automatic adjustment. When the
headlamp switch is placed in AUTO position, headlamps will
illuminate/go off according to the lighting brightness of ambient
environment. Daytime running lamps will automatically illuminate when
other lamps are not turned on after the engine is started.
Note: Initial position of head/amp switch is suggested to AUTO
position.
BEFORE YOU DRIVE
Position 3 - : Width lamps on. When width lamps are turned on, the
following lamps will be turned on meanwhile:
• Width lamps
• License plate lamp
• Instrument panel lamp
Position 4 - : Headlamps on.
Note: Head/amps can be turned on only when the Ignition switch is
placed In ON position. N head/amps are not turned off when the
vehicle is parked, battery will discharge. Then the engine may be
unable to start due to low battery. When the ignition switch is
placed in LOCK position or the key is pulled out, there will be
warning sounds if the headlamp switch is still turned on.
Position 5 - OFF: fog lamp off.
Position 6 - : Front fog lamps on. When the ignition switch is placed in
ON position and the lighting control switch is placed in or
position, turn the switch to , and then front fog lamps will be turned
on. When the lighting control switch is placed in AUTO position, and
the switch is rotated to position, the front fog lamps may illuminate
and go out with the headlamp according to the ambient circumstances.
When the front fog lamps are turned on, the ''front fog lamp indicator
lamp (green)" on the instrument cluster will illuminate.
Position 7- : Rear fog lamps on. When the ignition switch is placed in
ON position and the lighting control switch is placed in or
position, turn the switch to and then rear fog lamps will be turned
on. When the lighting control switch is placed in AUTO position, and
the switch is rotated to position, the rear fog lamps may illuminate
and go out with the headlamp according to the ambient circumstances.
When the rear fog lamps are turned on, the “rear fog lamp indicator
lamp (yellow)" on the instrument cluster will illuminate.
Note: Rear fog lamps shall not be used until the visibility is
obviously restricted (such as heavy fog or snow).
Turn signal lamps and direction indicator lamps
Turn right- push the stalk switch downwards.
Turn left - pull the stalk switch upwards.
Then the corresponding turn signal lamp and the “direction indicator
lamp (green)" on the instrument cluster will illuminate simultaneously.