MG Gloster, Manual, Page: 116 / 264

108 109
STARTING AND DRIVING
Note: The vehicle Is equipped with electronic hands-free key
Ignition switch, that Is, the start-stop switch for button-type start.
To start the vehicle, the PEPS key must be in the vehicle. For an AT
model, if you want to move the shift lever out of P, you must
depress the brake pedal with the ignition switch in ON position.
ACC - red lamp
• Start Failure
In case of engine start failure, the ignition switch will switch to ACC.
• Abnormal Parking
Before reading this chapter, please make sure you have read the
Before You Drive section in this manual and you have been familiar
with your vehicle and on-board equipment.
Before Starting and Driving
• Conduct daily/weekly maintenance checks on the vehicle in
accordance with the provisions in Maintenance- Owner Checks.
• Ensure seats are in correct positions through check.
• Ensure all rearview mirrors are adjusted to correct positions through
check.
• Ensure all lighting, signal systems and warning indicators operate
normally.
• Ensure all passengers have fastened their seat belts correctly through
check.
Move the ignition switch in “ON" position, and ensure all warning lamps
and gauges operate normally through check. Please refer to "Warning
Lamps and Indicator Lamps" in the Before You Drive section.
Ignition Switch
Keyless Start
Caution
STARTING AND DRIVING
When the engine is running and the shift lever is not in P gear,
press this button and ignition switch will switch to ACC.
• Emergency Flame out
When the vehicle speed is higher than 5km/h during driving, press
the ignition switch for 3 times continuously or long press it for 3s,
the ignition switch will switch to ACC.
Note: Red lamp flashing 3 times indicates that a legal physical
key/Bluetooth key is not detected in the vehicle.
ON - Green lamp
When the engine shuts down and the starting conditions are not met,
press this switch once, the ignition switch will switch to ON; after the
engine is normally started, the ignition switch will switch to ON; when
in ON state, all instruments, control devices and circuits can operate.
Nota: If the ignition switch is still placed in ACC or ON position
after engine shutdown, the battery power will be drained. The
vehicle may be unable to start if the battery power drain time is
too long.
START - green lamp
This position is used for starting the vehicle. When the engine shuts
down, there is an effective remote key in the vehicle and the starting
conditions are met, press and release this button, and then engine will
Starting conditions:
• Place the shift lever in P or N position.
• Depress the brake pedal and hold.
OFF
This position shuts down the engine. When the shift lever is placed in P
position, press this switch and the ignition switch will switch to OFF.
When the vehicle is close to strong radio antenna signals, there may
be an interference effect on the remote door lock system and the
start-stop switch will not work.
Caution