MG Gloster, Manual, Page: 192 / 264

184 185
EMERGENCY TROUBLESHOOTING
Hazard Warning Lamps
When you need to stop or slow down the vehicle in case of a vehicle
failure, always press the hazard warning lamp switch on the
instrument panel. The “Direction Indicator (green)" on the instrument
cluster flashes, and all the turning signal lamps shall flash at the meantime
to warn other road users as well as let the police know that you are in
trouble.
Warning Triangle
The warning triangle is placed at the bottom of the luggage
compartment(for vehicles with three rows of seats) or behind the
second row of seats (for vehicles with two rows of seats).
If you have to stop your vehicle on the roadside in case of a vehicle
failure, you must place a warning triangle approximately 100 meters
behind your vehicle to warn the oncoming vehicles.
EMERGENCY TROUBLESHOOTING
Wheel Replacement
J
ack
Placement
The jack is placed at the bottom of the luggage compartment (for
vehicles with three rows of seats) or behind the second row of seats (for
vehicles with two rows of seats).
Specification
This jack is for tyre replacement only. Do not use it for
other purposes. This jack is for your vehicle model only
and thus should not be used for other models.
Spare wheel
Regularly check the air pressure of spare wheel. The use
of a spare wheel with incorrect tyre pressure will affect
wheel stability, which may lead to dangerous
consequences and will cause permanent damage to the
tyre.
The spare wheel is mounted at the rear bottom of the body; the wheel
nut wrench and jack auxiliary rotary post in the vehicle tool kit can be
used to rotate the pillar bolt of drive mechanism, thus releasing or
tightening the rope for the spare wheel to achieve the function of spare
wheel replacement.
After replacing with the small size spare tyre, the vehicle speed shall
not exceed 120 km/h, or the risk of accident may occur. Avoid wide
open throttle acceleration, hard braking and sharp turn as much as
possible. It is better replace the small size spare tyre with the full size
tyre as soon as possible, thus to extend the service life of the spare
tyre and keep it in good state.
Spare wheel removal
1 Take out the vehicle tool.
2 Fold the seat back of third-row seats (if available) forward .
3 Mount the auxiliary rotary post and the wheel nut wrench.