MG Gloster, Manual, Page: 47 / 264

39 38
BEFORE YOU DRIVE
Plastic Hooks for Side Seat Belts
When not in use, the side seat belts for second and third rows can be
snapped into the side seat belt hooks.
Seat Belt Warning Lamp
For the specific details of “Seat Belt Warning Lamp”, please refer to
“Information Center” and “Warning Lamps and Indicators” in this
Ensure that the sliding adjuster Is secured after the
adjustment.
Do not adjust the height of the driver seat belt when
driving, or the vehicle may be out of control.
Seat Belt Height Adjustment
Only the height of the driver and front passenger seat’s lap-shoulder
belt can be adjusted.
Push the button (1) upward and slide the height adjuster on the top of
the belt up and down to suit the occupant height. Release the button (1)
at the proper position, pull the seat belt forcibly to ensure that the
vertical adjuster is locked reliably.
BEFORE YOU DRIVE
Do not damage or repair the pretensioner. As it contains
the ignition device, so it can only be repaired by our
Service Dealer.
The pretensioner will be invalid once being activated, so
it must be replaced. Ensure that our Service Dealer has
checked and repaired the pretensioners and all seat belt
components after the collision.
Seat Belt Pretensioner
The seat belt pretensioner works with the airbag to reduce the risk of
injury caused by the frontal impact. Refer to "Airbag" in this chapter for
Airbag
None protection device is absolutely safe, when used to
avoid the occurrence of serious collision, it may result in
the personal injury or death. Even though the seat belt is
worn properly and the airbag is inflated, it may also
result in the personal injury or death.
When inflated, some components of the airbag will be
hot, so do not contact it before cooling down.
Airbag inflation may lead to the occupant facial
abrasions or other injuries, such injuries can be
minimized only if you and your occupants wear the seat
belt.
The driver seat should be adjusted to the back as far as
possible without affecting your driving.
Always hold the steering wheel rim, so that the airbag
would not be interfered when inflating.
Do not put any accessory (eg. mobile phone holder, cup
base, tray) on the steering wheel cover or the airbag
cover plate of the instrument panel, also do not paste (or
insert) any objects onto the airbag module cover.
Otherwise, it will affect the airbag inflation, or these
objects will be blown to any area of the interior when the