28
D39303 | Date 09/2018
Operation and control
The display now shows the remaining time
in a large font and the approximate end time
in a smaller font beneath. The status display
shows
Timer active
.
TIMER
30
m
04
h
End 13:30 23.11.
Timer active
12.09.2012
13:44
4. Now, as described under 5.5.2, set the individual values which you want the appliance
to operate at. The set values can be changed at any time while the timer elapses. The
changes are effective immediately.
In
Setup
, you can choose if the timer should be setpoint-dependent or not. This deter-
mines whether the timer should not start until a tolerance band around the set tempera-
ture is reached or if it should start immediately after activation (see page 44). The
symbol on the timer display indicates that the timer is set to setpoint-dependent.
Once the timer has finished, the display shows 00h:00m.
All functions (heating etc.) are switched off. In addition, an
acoustic alarm sounds, which can be turned off by pressing the
confirmation key.
Note that condensation may occur in the interior after you
switch off the heating.
To deactivate the timer, open the timer display by pressing the
activation key again and then turning the turn control to reduce
the timer setting until --:-- is displayed. Press the confirmation key
to confirm.
5.5.6
Program mode
In this operating mode, programs saved in the appliance can be started with different
combinations of individual parameters (temperature, humidity, etc.) at staggered intervals,
which the appliance then automatically processes in sequence. These programs are not cre-
ated directly at the appliance but externally at a computer / laptop and using AtmoCONTROL
software. Transfer to the appliance is possible using the provided USB storage medium or via
Ethernet.
A description of how to create and save programs can be found in the separate
AtmoCONTROL software manual.
Starting a program
1. Press the activation key next to the status
display. The current operating mode is
highlighted automatically, in this example
Manual mode
(
).
Holz trocknen
aufheizen
09:12h
Fr 20.10.2010 20:31
off
ON
LIGHT
ON
LIGHT
Manueller Modus
12.09.2012
13:44
Manual mode
12.09.2012
13:44
Activate
2. Turn the turn control until the
start
symbol is highlighted. The current
program is displayed, in this example
Test012
.
13:44
Test 012
Ready
12.11.2012
TIMER
00
m
00
h
End 13:30 23.11.
TIMER
--
m
--
h
End 9:00 23.11.
Summary of Contents for HCP105
Page 1: ...HCP OPERATING MANUAL HUMIDITY CHAMBER HCP...
Page 59: ......
