![background image](http://html1.mh-extra.com/html/martin/dt2h/dt2h_installation-manual_1732845037.webp)
© Martin Engineering GmbH
27
M3699UK-11/13
Maintenance
.
2. Clean and inspect the scraper blades. Replace worn out scrap-
er blades as described in the following:
• Loosen the screws (Fig. 21, 3) and remove the end stop
(Fig. 21, 2). Next, pull out the scraper blades (Fig. 21, 1)
from the cartridge. If the scraper blades cannot be
removed, at least one side of the lateral guide rails (Fig. 21.
4) must be loosened or removed.
• Slide in the new scraper blades and pay attention to the
alignment of the scraper blades.
• Insert the end stop again. (In case of severe wear and tear,
it may become necessary to replace the end stop).
• Place the scraper blade cartridge again on the scraper
shaft and insert the locking pin on the operator side. Re-
tighten the scraper.
Abb. 19: Replacing the scraper blade
NOTE
The end stops may prevent damage to the conveyor belt by sup-
porting the conveyor belt at the edges of the scraper blades. If
both end stops need to be removed, first mark their position in the
cartridge so that the scraper blades can be positioned properly
after assembly.
3
2
1
4
Summary of Contents for DT2H
