© Martin Engineering GmbH
21
M3699UK-11/13
Installation
8. If the wear and tear or bulk material accumulation is excessive
or other problems occur, refer to the information in section 4.4
“Installation checklist” or chapter 6 “Troubleshooting.
4.4
Installations - Check-list
If the test run of the conveyor belt scraper was not as expected, then
the “Installation checklist” table could help to find and solve the prob-
lem. If there are still problems, refer to chapter 6 "Troubleshooting".
Installation checklist
The main scraper must be installed on both sides according to the
measurements in section 4.2 et seq.
The tip of the main scraper cleaner blade must touch the conveyor
belt in the range of 51 and 102 mm after the vertical centre line of
the head drum.
The main scraper should not raise the conveyor belt (see Fig. 19).
The scraper blades must be installed in the centre of the conveyor
belt and/or head drum.
Tab. 4: Installation check-list
Summary of Contents for DT2H
