© Martin Engineering GmbH
19
M3699UK-11/13
Installation
4.3
Test run
1. If the main scraper raises the conveyor belt, then a pressure
roller must be mounted above the contact point between the
scraper blade and the conveyor belt at a distance of 50 mm
against the direction of conveyance to support the belt.
2. Carefully wipe the outer chute wall on the operator side above
the scraper. Affix the warning labels for the conveyor belt prod-
ucts (Part no. 23395) so that they are visible to the system op-
erator at the chute wall - see also Fig. 17 on page 31 for this
purpose.
NOTE
Read through this section thoroughly before starting any work on
the conveyor belt scraper or the customer's conveyor belt system.
Abb. 15: Conveyor belt without counter pressure roller
Abb. 16: Conveyor belt with counter pressure roller
Conveyor belt surface
of the conveyor belt
Direction of movement
Direction of movement
of the conveyor belt
approx. 50 mm
Summary of Contents for DT2H
